BeM LINK – Adapter Support for Bench Testing Blue&Me FCA Units

Professional Blue&Me Unit Testing

BeM LINK allows you to connect and bench test Blue&Me FCA units without having to install them in the vehicle.

The device reproduces the main electrical connections and connections necessary for module operation, allowing the technician to perform diagnostic and functional checks after repair or reprogramming.

It is compatible with first and second generation Blue&Me units, including Convergence platforms manufactured by Marelli and Lauberhorn.

Repair Verification Before Installation

After repairing or reprogramming a Blue&Me unit, BeM LINK allows you to verify its operation directly on the workbench.

This allows you to identify any residual faults before reinstalling the module in the vehicle, reducing the risk of repeating removal and installation operations.

Bench testing therefore represents a fundamental step in validating the work result.

Diagnostic Tool Connection

BeM LINK allows you to connect a compatible generic diagnostic tool to:

• verify communication with the Blue&Me unit;
• read stored errors;
• clear errors, when permitted;
• view operating parameters;
• check module status;
• perform available diagnostic procedures.

The functions actually accessible depend on the diagnostic tool and software used.

USB Port Testing

Via the USB port, you can connect a compatible mass storage device and verify the Blue&Me unit interface operation.

Depending on the module version and available files, you can perform operations such as:

• verification of USB memory recognition;
• language change;
• configuration information retrieval;
• system update;
• USB device communication testing.

TRRS Audio Input and Output

The TRRS audio jack allows you to verify the Blue&Me unit audio functions.

It can be used to:

• listen to voice messages generated by the system;
• verify audio output;
• issue voice commands or signals;
• check hands-free function operation;
• verify audio sections after repair.

Supported Units

BeM LINK is designed for first and second generation Blue&Me FCA units, including the main Convergence versions:

• Marelli;
• Lauberhorn;
• Xilinx XC3S400-based units;
• ARM STA2062 and STA2062A-based units.

Compatibility must be verified based on unit model, connector, and hardware configuration.

Important Information

BeM LINK is a professional tool intended for electronic workshops and specialized operators.

Before powering the unit, verify correct connection configuration and power supply compatibility.

Do not connect or disconnect the module while the device is powered.

Diagnostic tool, USB memory, audio cables, Blue&Me unit, and accessories not expressly indicated in the selected variant are not included.